Mounting the motors

  • Screw the brackets down as illustrated below (one on each end of the top beam) - use medium size screws (bag #4)
  • Bolt the motors to the brackets (bag #6)
  • Install the two sprockets using the included Allen wrench (bag #5)

Installing the Control Board

  • Attach the electronics to the back of the top beam using the screws and nylon spacers in bag #5
  • Connect the motors to the controller as shown below
  • NOTE: The control board's firmware comes pre-installed already (plug and play).

Connecting to the machine

  • Open Ground Control and connect to the machine
  • Click on --> --> and select the port from the list ->

Begin Calibration

  • Click on --> --> --> [Begin]
  • Follow on-screen instructions

Reference Image


  • Your machine is now calibrated and ready to cut.
  • Please, go to the next final step.